II. Once you’ve done above, you shall see the following:

Image Source Type?
CD DVD

This screen will allow you to specify what type of Image it is. You can press UP or DOWN arrow button to specify whether it is “CD” or “DVD”. Then you can press “>>” button to start loading.

III. Once your master disc has been recognized. The loading progress indicator will be displayed and you shall see the following:

Loading ...
123 MB Loaded

*The “123MB” indicates the amount of data has
been loaded to the Hard Drive.

IV. Once your master disc has been loaded completely, you shall see the following:

Load Image OK
Press OK to Continue

Then, you can press “>>” button to go back to the HDD Image Setup Menu.

NOTE: After loading your master disc to the Hard Drive, please make sure that you have removed your master disc from the Master Reading Tray before proceed to copy process. Fail to do so will cause improper duplication.

3. Assign the current Active Image

The active image is the image that the duplicator will be dealt exclusively. After you have loaded your master disc to the HDD as an image, it will be automatically assigned to the one you’ve just loaded. However, it is a good habit to make sure the correct image is selected as the active image. To do so, please follow instructions below:

a. Use UP or DOWN arrow button to navigate to the following screen.

HDD Image Setup
1.Select Image

b. Press “>>” to enter Load Image Menu and you shall see the following:

Choose Image
1->[FUN ] DVD

c. Use UP or DOWN arrow button to find the desired image and then press “>>” to submit your selection and you shall see the following for 2 seconds.

Image [FUN ] DVD
Selected!

Then, you will be directed back to HDD Image Setup Menu.

HDD Image Setup
1.Select Image

4. Go back to “COPY” Menu.

a. Press “<<” button to go back to the main menu. You shall see the following:

DUPLICATOR 1.00
10. HDD Image Setup

b. Use UP or DOWN arrow button to navigate to the following screen.

DUPLICATOR 1.00
1. COPY