| c. Press “>>” to submit your selection. After your selection has been submitted, your will see the following:
DUPLICATOR 1.00
8. Select Source
2. Load your master disc onto the Hard Drive. If you have already loaded your master disc onto the Hard Drive, then you can skip step 2 and go to step
a. Use UP or DOWN arrow button to navigate to the following screen.
DUPLICATOR 1.00
10. HDD Image Setup
b. Press “>>” to enter HDD Image Setup Menu and you shall see the following:
HDD Image Setup
1.Select Image
c. Now, let us load a master disc to the Hard Drive. To do so, let us use UP or DOWN arrow button to navigate to the following screen.
HDD Image Setup
2.Load Image
d. Press “>>” to enter Load Image Menu and you shall see the following:
Load Image [ 0/ 6]
Load->New Partition
*The “0” indicates the number of images you’ve already loaded into the Hard Drive and “6” indicates the total number of images you can load to.
***The number of partition is determined by dividing your Hard Drive’s total capacity by 5.1 GB and subtracts one partition for system use. For example, if you have a 40GB Hard Drive, then you can calculate the number of partitions by: 40 / 5.1 – 1 = 6.84. Since you can’t use any incomplete partition, therefore you only have 6 partitions is available for 40GB Hard Drive.
|
e. Now, you have a choice to load your master disc into a new empty partition or overwrite one of the existing one if any exists. You can simple press UP or DOWN arrow button to select your partition and press “>>” to submit. You will see the following:
Enter HDD Image Name
[ ] OK
f. Now, you can name the image you are about to load into the Hard Drive. To enter the name, you need to use UP or DOWN button to select the character and use “>>” or “<<” button to move the cursor position and once you finished, move the cursor to “OK” and press “>>”. For example, if you want to name your master disc image as “FUN”, then do the following:
I. Make sure the cursor is located at the first position:
Enter HDD Image Name
[x ] OK
i. Press “DOWN” button consecutively until “F” is displayed.
ii. Press “>>” button once to move the cursor to the next position.
iii. Press “DOWN” button consecutively until “U” is displayed.
iv. Press “>>” button once to move the cursor to the next position.
v. Press “DOWN” button consecutively until “N” is displayed.
vi. Press “>>” button once to move the cursor to the next position.
vii. Now, we have the name “FUN” displayed and then, press “>>” consecutively until the cursor is moved to “OK”.
viii. Then, press “>>” once to submit your name selection.
|
