Fusion Manual Pg 24

Fusion Manual HTML Format Page 24


The blank discs will be loaded one at a time from the input bin, into the recorders. Upon successful completion, the discs will be ejected one at a time, and unloaded onto the output spindle or bin more blank discs will be loaded one at a time from the input bin, into the recorders, and the copying process will continue as before. However, if the input bins run empty, the job will be considered to be complete and screen will display the following:

Pressing any key will take you back to the main menu • If you wish to make additional copies of the same master disc; place as many blank discs as are needed into the input bin, starting with BIN 1, and start the Batch Mode process. • If you wish to make copies of a different master disc; place as many blank discs as are needed into the input bin, and place your new master disc on top of the stack of blank discs. Press the “START/YES” key. The copying process will proceed as before, but the new master disc will overwrite the image of the previous master on the hard disk drive. • If you wish to stop the copying process, press the “STOP/NO” key. This requires a sustained push of two seconds to ensure the “STOP/NO” key was not pressed accidentally. You will then be returned to the main operating screen, after recalibration (resetting the picker to its home position).
Note: Any discs dropped on the deck of the unit underneath the drive bays have failed to copy properly, and should not be used. Be sure to remove rejected discs periodically during operation.

< Previous Page / Next Page >